Preparation
In order to clean the decorative bricks, apply using an acid-resistant
synthetic brush RIALTO ALKAL "1", based on acid fluorides.
Average covering capacity: 600 g/m². Allow approximately
30 minutes, then rinse thoroughly using a pressure-washer and
adding 1 l of RIALTO NEUTRAL "K1" for every 50-60 l
of water. Check and seal perfectly all bricks joints using RIALTO
WALLCEM, a non-cracking elastic mortar. Remove immediately any
excess of material on the bricks.
Finishing
Starting from the bottom and working upward, apply to fully saturate
the surface a coat of RIALTO SILAN, an absorption-regulating,
colorless, non-film-forming, transparent, water vapor permeable,
protective water-repellent treatment based on oligomeric siloxane
alkylates. Protect from rain for at least 24 hours.
Average covering capacity: 250 ml/m².
Price for material and application, excluding any scaffolds, €
…….. per m²
|
