Preparation
Remove any loose paint or plaster material. Dampen, patch and
level (average thickness: 3 mm) the entire surface spreading with
a steel trowel RIALTO WALLCEM (adding 10% of RIALTO MATONAL).
After approximately 30 minutes, FINISH off with a wet sponge trowel.
Where the surface is damaged, incorporate RIALTO FIBRATEX, an
alcali-resistant fiberglass (width: 25 cm). Average covering capacity
for 1-mm thickness of RIALTO WALLCEM: 1.2 kg/m². Allow the
surface to dry completely before applying one coat of RIALTO STABILIZER,
an insulating hardening undercoat based on resins in aromatic
and aliphatic solvents, either using a brush or a roller. Average
covering capacity: 170 ml/m². Allow at least 24 hours before
applying the finishing product.
Finishing
Apply RIALTO UNION, with smooth and satin effect, a terpolymer
and water-based sanitizing permanent acrylic paint for exterior
surfaces composed of UV ray-resistant pigments, selected siliceous
mineral aggregates, and a broad-spectrum permanent-action fungicide-bactericide
agent. It is water-repellent, water vapor permeable (DIN 53122
Regulations, 47 g/m² - 24 hours, µ=2227, Sd=0.49 m)
and has high hiding power.
Average covering capacity on fine plaster: 150 ml/m². Apply
two coats either by roller or spray. Dilute first coat to 20%
with water and second coat to 10% with water.
Price for material and application, excluding any scaffolds, €
…….. per m² |
