Preparation
Remove any loose paint or plaster material. Dampen, patch and
level (average thickness: 3 mm) the entire surface spreading with
a steel trowel RIALTO WALLCEM (adding 10% of RIALTO MATONAL).
After approximately 30 minutes, FINISH off with a wet sponge trowel.
Where the surface is damaged, incorporate RIALTO FIBRATEX, an
alcali-resistant fiberglass (width: 25 cm). Average covering capacity
for 1-mm thickness of RIALTO WALLCEM: 1.2 kg/m². Allow the
surface to dry completely before applying one coat of RIALTO STABILIZER,
an insulating hardening undercoat based on resins in aromatic
and aliphatic solvents, either using a brush or a roller. Average
covering capacity: 100 ml/m². Allow at least 24 hours before
applying the finishing product.
Finishing
Apply using either a roller, spray or brush the single-can enamel
paint RIALTO GLAZER, based on water, acrylic resins and UV ray-resistant
pigments. It is a non-yellowing and non-blocking enamel-paint,
resistant to abrasion and corrosive action of atmospheric agents,
water vapor permeable and non-flammable.
Average covering capacity: 1 l / 8-10 m² if applied by brush
or roller, 1 l / 7-8 m² if applied by spray.
Price for material and application, excluding any scaffolds, €
…….. per m² |
