Preparation
Remove any loose paint or plaster material. Dampen, patch and
level (average thickness: 3 mm) the entire surface spreading with
a steel trowel RIALTO WALLCEM (adding 10% of RIALTO MATONAL).
After approximately 30 minutes, FINISH off with a wet sponge trowel.
Where the surface is damaged, incorporate RIALTO FIBRATEX, an
alcali-resistant fiberglass (width: 25 cm). Average covering capacity
for 1-mm thickness of RIALTO WALLCEM: 1.2 kg/m². Allow the
surface to dry completely before applying one coat of RIALTO STABILIZER,
an insulating hardening undercoat based on resins in aromatic
and aliphatic solvents, either using a brush or a roller. Average
covering capacity: 170 ml/m². Allow at least 24 hours before
applying the finishing product.
Finishing
Apply two coats, using a brush or a roller and allowing at least
8-10 hours between first and second coat, of RIALTO FINISH, a
protective coating with smooth mat suede-like decorative effect
and based on selected inert minerals (mica and quartz), a thermoplastic
terpolymer binder, a fungicide-bactericide agent, and UV ray-resistant
pigments. Surface adherence not lower than 8 kgf/cm² and
water-repellent with water vapor permeability equal to 30 g/m²
- 24 hours (ASTM E96 Regulations, µ=2860, Sd=0.71 m).
Average covering capacity on fine plaster: 290 ml/m².
Price for material and application, excluding any scaffolds, €
…….. per m² |
